Cost Info

A Claude Code mod that shows what your session has cost so far, and the tokens it took, live.

• Under the prompt. ◉ $0.16 | Token Usage 142k / 30k | now $0.02 at the right of the line under the prompt, the figures in green, live, mid-turn too; once the turn ends now becomes last. A narrow terminal (under 120 columns) shows the session alone. The cost is the same figure /cost shows, subagents included.
• Tokens. Every model request's input, cache writes, cache reads and output, summed, subagents included.
• Budget. A one-time warning when the session crosses it.
• /spend. Tokens, turns, average per turn, your priciest turn, and how much of the budget is used.
• VS Code. The extension doesn't draw that line, so there the meter opens as a Cost pane. Run /spend to bring it back if you close it.

On a Pro or Max plan the dollars aren't what you're billed, so when Claude Code reports rate limits the meter shows how much of each is used instead: ◉ 5h ━─── 15% wk ━─── 7% Resets in 3h 55m | Token Usage 104k / 70k: a thin gauge for the 5-hour and weekly windows, and the time until the sooner one resets. It reads what Claude Code already receives, so it costs nothing extra. Without rate limits (API billing) it shows cost as before. Tokens count from when the mod loaded into the session, so a resumed session's earlier tokens aren't in the total.

Install

Requires Claude Code 2.1.288 or later. Run these in a shell, not inside a Claude Code session:

claude plugin marketplace add falconsw/cost-info
claude plugin install cost-info@falconsw-mods

Then load it into your open Claude Code session:

/reload-plugins

Or start a new session, in the terminal or in VS Code.

To get a new version, run claude plugin update cost-info@falconsw-mods, then /reload-plugins. If it says it's already at the latest version, run claude plugin marketplace update falconsw-mods first. To remove it, run claude plugin uninstall cost-info@falconsw-mods.

Configure

The budget is $5 unless you set it; 0 turns it off. Set it from a shell, the value written as a string, then restart Claude Code:

echo '{"budget": "10"}' | claude plugin configure cost-info@falconsw-mods --values-stdin

Or set it while installing:

claude plugin install cost-info@falconsw-mods --config budget=10

claude plugin configure cost-info@falconsw-mods shows whether it's set.

Develop

claude plugin validate ./cost-info
claude plugin test ./cost-info
claude --plugin-dir ./cost-info   # reloads as you save

A mod runs inside Claude Code with the same access Claude Code has. Read the source before you install it: it's one file, cost-info/hooks/register.tsx.